Attaching the Companion Board
(DP-XXXXC)
This door intercom product consists of two sub assemblies which must be attached to each other before the final assembly can be installed. In this guide the electronic sub assembly will be referred to as the “Companion Board” and the mechanical assembly will be referred to as the “Door Plate.” Review the following diagrams and assemble as shown.
Companion Board Connection Details
Volume Adjustment |
Microphone |
(attached to back side) |
To Speaker | To Button |
|
Position the companion board onto the three mounting tabs as shown below. The microphone attached to the back side of the companion board should line up with the microphone tube on the bracket. Bend the mounting tabs to secure the companion board. Connect the speaker and button wires by sliding the small connector over the exposed pins on the companion board as shown.
Microphone Companion Board
Tube
Attach button and speaker wires as shown
Align holes with | Bend mounting tabs |
mounting tabs | |
| over to secure the |
| Companion Board |
Completed
Connect Intercom Hub here (see following pages for details)
6