3M 2470, 2475 installation instructions Programming State, Parameter # Name/Value

Performance Series Programming the System

Programming the System

!Important

If you have not selected the mode of operation (Pump or Island) do so now! See System Mode Selection.

Programming State

1	2	3
4	5	6
7	8	9	T
			A
	MENU		L
	0		K

SP-389C

Figure 11. D-2400 Keypad

To program the Performance Series Intercom System, it is necessary to put the system in the programming state. From this state, the entire system is configured and all memorized parameters are adjusted.

To enter the programming state, simultaneously: Press and hold the STD BY key.

Enter the numeric code: 97531. The display shows:

01:Selector ID # {01}

The Parameter #, Parameter Name/Value, and Parameter Value fields are as shown below.

	Parameter
Parameter #	Name/Value
↓	↓
01:Selector ID #
	{01}← Parameter Value

The “_ “ indicates cursor position. To move the cursor from one field to another, use the Left Arrow and Right Arrow keys.

To input data at the cursor position, do one of the following:

•Use the Up Arrow and Down Arrow keys to scroll to desired value.

•Use the 1, 2, 3, 4, 5, 6, 7, 8, 9, 0/Menu keys.

The STD BY key clears a field to a default value (space for text or the default value).

The HOLD key shifts case for text data.

The ALL CALL key exits from the programming state and enters the Off Line mode.

!Important

All Station Selectors ship from the factory with a default ID number of 15. It is important to connect and power up each new Station Selector, ONE STATION SELECTOR AT A TIME, when installing a new system. Doing this allows you to change the ID number to a lower value (start at 1) and avoid the erratic behavior caused by multiple Station Selectors sharing the same ID number.

11