Mounting with Tape
Step 1
Clean back of doorbell and mounting surface using the alcohol wipe.
Step 2
Peel off white paper from mounting tape. Firmly press mounting tape on back of doorbell.
Step 3
Peel paper from mounting tape. Firmly press doorbell onto mounting surface.
Secure Cover
Secure cover with the two large black screws.
Program Additional Intercoms
The intercom can be programmed to at least one other intercom to become a network or it can be programmed into an existing network.
Create New Network
Press the Learn button on the new intercom until a beep is heard. Within 10 seconds put the second intercom into Learn Mode (refer to table below).
INTERCOM | LEARN MODE |
| Press the Learn button until |
OR | a beep is heard. |
|
Press and hold both buttons for 5 seconds.
Each intercom will emit a tone when programmed into network. Repeat for any additional intercoms.
Add to an Existing Network
Press the Learn button on the new intercom until a beep is heard. Within 10 seconds put any networked intercom into Learn Mode (refer to table below).
INTERCOM | LEARN MODE |
| Press the Learn button until |
OR | a beep is heard. |
|
Press and hold both buttons for 5 seconds.
Each intercom will emit a tone when programmed into network. Repeat for any additional intercoms.
NOTE: Do not program new intercoms to each other before adding them to the network or they will form a separate network and the memory will need to be cleared.
3