Replace the rechargeable handset battery pack

1.Remove the 4 screws holding the battery compartment with a screwdriver and take off the battery cover. Remove the old battery pack in the battery compartment.

2.Plug the replacement battery connector (red & black wires) into the small, black jack inside the battery compartment. (The connector notches fit into the grooves of the jack only one-way.) Match the wire colors to the polarity label in the battery compartment, connect the battery and listen for a click to insure connection.

3.Make certain you have made a good connection by slightly pulling on the battery wires. If the battery connector is not securely connected, the handset will not charge properly.

4.Before placing the battery cover back on the handset, make sure there is no foreign matter under the rubber seal located on the under side. By inserting the bottom first, place the battery cover back on the handset and tighten the 4 screws.

If the rubber seal appears warn, nicked, or dried out, replacement seals are available through the Uniden Parts Department. If you have questions regarding the installation of the battery pack and/or rubber seal, please call our Customer Service Hotline at 1-800- 297-1023.

Rubber Seal