Panasonic SC-HT67 warranty Maintenance, Picture, Listening to the radio, Unit displays

Picture

Picture distorted.	≥Some distortion is normal during SEARCH.
No picture.	≥Ensure that the television is connected properly. 8
	≥Make sure the television is on.
	≥Ensure the television’s video input setting (e.g., VIDEO 1) is correct.
The picture shown on the	≥Go to the Video menu in the SETUP screen, and change “TV Aspect” to suit your television. You
television is not normal.	may also need to change the screen mode on the television itself. 9 H
(The sides of the picture are cut	≥Ensure that the unit is connected directly to the television, and is not connected through a video
off or black bands appear at the	cassette recorder.
top and bottom of the screen.)
Picture quality is poor.	≥Check the settings in the On-Screen Menu Icons’ video menu. A
The picture on the television	≥The location and orientation of the antenna are incorrect. If you are using an indoor antenna,
disappears or stripes appear on	change to an outdoor antenna. M
the screen.	The television antenna wire is too close to the unit. Separate the antenna wire of the television
	from the unit.
Listening to the radio

Noise is heard.

The stereo indicator flickers or doesn’t light.

Sound is distorted.

A beat sound is heard.

A low hum is heard during AM broadcasts.

≥Adjust the position of the FM or AM antenna. 8 ≥Use an outdoor antenna. M

≥Turn the television off or separate it from the unit.

≥Separate the antenna from other cables and cords.

Unit displays

This unit’s display is off.	≥Press [FL DISPLAY] to turn the display on. G
“NO PLAY”	≥You inserted a disc the unit cannot play; insert one it can. 5
“NO DISC”	≥You haven’t inserted a disc; insert one.
	≥You haven’t inserted the disc correctly; insert it correctly. ;
“F61”	≥Check and correct the speaker cord connections. 7
	If this does not fix the problem, there is a power supply problem. Call 1-800-211-PANA for support.
“DTS NO AUDIO”	≥This unit is unable to decode DTS signals.
“DTS CD”	≥This unit is unable to decode DTS signals.
“DVD U11”	≥The disc is dirty. Wipe it with a soft cloth. 5
“ERROR”	≥Incorrect operation performed. Read the instructions and try again.
“DVD H∑∑”	≥Trouble is likely to have occurred. The number following “H” depends on the status of the unit.	Reference
	Reset procedure:
∑∑ stands for a number.	Press [Í] to switch the unit to the standby mode and then back to ON. Alternatively, press [Í] to
	switch the unit to the standby mode, disconnect the AC power supply cord, and then reconnect it.
	≥If the service numbers fail to clear, note the service number and contact a qualified service person.
“TAKE OUT DISC”	≥A problem has occurred with the tray mechanism. The tray will open automatically. Take out the
	disc and close the tray. The unit will make the disc changing noises for a few moments and then
	should operate normally.
Television displays

No on-screen display.

On-Screen Menu Icons not displayed or only partially displayed on the television.

The disc’s menu is displayed in a different language.

≥Go to Display in the SETUP menus, and select “On” for “On-Screen Messages”. H

≥Press [3, 4] while the rightmost icon is highlighted to move them down. @

≥Go to Disc in the SETUP menus, and select the preferred language for “Menus”. H

Maintenance

To clean this unit, wipe with a soft, damp cloth.
≥Never use alcohol, paint thinner or benzine to clean this unit.
≥Before using chemically treated cloth, read the instructions that came with the cloth carefully.	31

RQT6191