Troubleshooting

Blank or faint screen

Check the line cord.

Replace batteries.

Check the AC Adaptor is plugged in and switched on.

Caller ID will not work

If you have an answering machine or fax connected to this phone, ensure it is set to answer after at least two rings.

You have answered the call before two rings.

Contact your telephone company if the problem continues for more than 24 hours. The telephone company may be experiencing a temporary line fault.

Phone will not ring

You may have too many communication devices connected to a single line. A communication device can be a phone, a modem or fax machine. Disconnect some devices.

No dial tone

Verify that you are using the correct line cord and that it is plugged in correctly.

No response on LCD display

If you have experienced a power failure when using the AC adaptor, the batteries for memory backup may have become weak or dead. If the power is restored and the display screen does not respond then you need to replace the batteries. Press the reset button.

New Call light will not stop flashing

Review all new calls

Press the reset button to clear all memory

Call Waiting (flash) does not work

Check the flash time is set correctly for your country

Please refer to our website for further information and frequently asked questions.

New Zealand - www.uniden.co.nz

Australia - www.uniden.com.au