Required System Configuration

Connecting the Cradle to a Computer

The cradle has a serial cable for connection to a personal computer. Connect the end of the cable to a serial port of the computer to which you want to connect.

Important

∙See “Required System Configuration” on page 20 of this Hardware Manual for details on the type of computer system required for use with the cradle.

∙Be sure to turn off the CASSIOPEIA and your computer before connecting the cradle.

∙The above illustration is one example of possible connection configurations. The location and layout of serial connectors vary from computer to computer. See the documentation that comes with your computer for full details on connecting to its serial ports.

∙The cradle can be connected directly to a 9-pin type serial port, which is the type used by most personal computers. You can also connect to a 25-pin serial port using an adapter.

∙Note that after connecting the cradle to your computer, you also need to make certain ActiveSync settings on your computer to enable data transfers. See the ActiveSync Help for details about setting up and using ActiveSync.

The minimum system configuration required for running ActiveSync® 3.1 is described below.

ActiveSync® 3.1 System Requirements

∙Microsoft® Windows® 2000, Windows NT® Workstation 4.0 with Service Pack 3 or greater, or Windows 95/98. (U.S. version)

∙Desktop computer with a Pentium processor for Windows NT (166MHz required for Windows 2000)

∙Desktop computer with a 486/66 DX or higher processor (Pentium P90 recommended) for Windows 95/98