2.4Installation of Satellite I/O Box (1 unit)
Environment Setup
1)Make sure that the POWER switch of the I/O Box is set to OFF.
2)Set the DIP switches provided on the rear panel to the following.
Table 2.1
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 |
ON | OFF | OFF | OFF | ON | OFF | ON | ON | ON | ON |
Note:
The above settings assume that the communication speed is set to 115,200 bps. To set a different baud rate modify the SW6, SW7, and SW8 settings as follows:
Table 2.2
Baud Rate | SW6 | SW7 | SW8 |
9,600 bps | OFF | ON | OFF |
19,200 bps | ON | ON | OFF |
38,400 bps | OFF | OFF | ON |
57,600 bps | ON | OFF | ON |
115,200 bps | OFF | ON | ON |
Connection
1)Connect the AC adaptor to the I/O Box.
2)Connect the I/O Box to the PC with the
1)Set the POWER switch to ON.
2)Make sure that the “READY POWER” lamp lights in green.
7