Panasonic KX-TG7521BX, KX-TG7511 Registering a handset to a base unit, Selecting a base unit

TG7511_7521BX(e).book Page 30 Tuesday, June 15, 2010 2:10 PM

Programming

Note:

L Calls are disconnected when the handset moves from one radio cell to another.

Registering a handset to a base unit

The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit (for example, _is displayed even when the handset is near the base unit), re- register the handset.

1Handset:

1i{#}{1}{3}{0}

2{V}/{^}: Select a base unit number. iM

L This number is used by the handset as a reference only.

3Base unit:

Proceed with the operation for your model.

■ KX-TG7511

Press and hold {x} for about 5 seconds. (No registration tone)

■ KX-TG7521

Press and hold {x} for about 5 seconds, until the registration tone sounds.

L If all registered handsets start ringing, press the same button to stop. Then repeat this step.

L The next step must be completed within 90 seconds.

4Handset:

Wait until “Base PIN” is displayed. iEnter the base unit PIN (default: “0000”). iM

L If you forget your PIN, contact an authorised service centre.

L When the handset has been registered successfully, w is displayed.

Selecting a base unit

When “Auto” is selected, the handset automatically uses any available base unit it is registered to. When a specific base unit is selected, the handset makes and receives calls using that base unit only. If the handset is out of range of that base unit, no calls can be made.

11i{#}{1}{3}{7}

2{V}/{^}: Select the desired base unit number, or “Auto”. iM L The handset starts searching for

the base unit.

Deregistering a handset

A handset can cancel its own registration that is stored to the base unit. This allows the handset to end its wireless connection with the system.

11i{#}{1}{3}{1}

2{V}/{^}: Select the handset you want to cancel. iM

3{V}/{^}: “Yes” iM

L A confirmation tone sounds.

L The handset does not beep when cancelling its own registration.

4{ic}

Cancelling a base unit

A handset can cancel a base unit that it is registered to. This allows the base unit to end its wireless connection with the system.

11i{#}{1}{3}{9}

2{V}/{^}: Select the base unit you want to cancel. iM

3{V}/{^}: “Yes” iMi{ic}

Note:

L To register a handset to another base unit or to the same base unit again, see page 30.

30