Panasonic RX-D26 manual Radio, · 2 ·

The radio

Normal tuning

2 1 3 4

1	Press [TUNER/BAND] to select “FM” or “AM”.
	(Unit comes on.)
2	If “	” is on the display, press
	[TUNE MODE] to clear it.
3	Press [– /		] or [	/ +] to tune
	to the desired station.

Automatic tuning

Press and hold [– / ] or [ / +] then release when the frequency display starts to change. A station with good reception is automati- cally selected and the process stops.

To stop automatic tuning, press [– / ] or [ / +] again.

Note

Automatic tuning may stop on a frequency where there is no station

if there is interference. Press [– / ] and [ / +] to tune if this occurs.

4 Adjust the volume.

To improve reception

FM: Extend the whip antenna and adjust its direction.

AM: Adjust the position of the unit.

If noise is excessive in the FM stereo mode

Press [FM MODE]. (“MONO” lights up.) Sound will be produced in monaural, but this also reduces noise.

Press the button again to cancel. (“MONO” goes out.)

For area except for United Kingdom and Continental Europe

AM allocation setting

Before receiving AM broadcasts, be sure to select the correct allocation setting (either 9 kHz or 10 kHz) for your area.

First press [TUNER/BAND] to select AM. Next, press and hold

[ / CLEAR]. The display changes in a few seconds to show the current lowest AM frequency. Continue to hold down the button.

When the minimum frequency changes, release the button. Changing the step erases all preset stations.

Repeat the above to change the step back.

Preset tuning

Preset the stations (20 FM and 12 AM) to make tuning simpler.

3

1 · 2 · 4

2 1 3

Automatic presetting

Do the following once each for FM and AM.

Preparations: Press [TUNER/BAND] to select “FM” or “AM”.

Press and hold [–AUTO PRESET] until “AUTO” is displayed.

The tuner presets stations it can receive into the channels.

Manual Presetting

Presets one station at a time. Preparations: Tune to the desired station.

(Perform steps 1-3on the left.)

1 Press and hold [–PGM].

2 While “ ” and the frequency display are flashing

Press [–PGM].

While “	” and the preset channel are
3 flashing
Press [–/		] or [	/+] to select
the desired channel.
			Preset channel
4 Press [–PGM].

Repeat the above to preset other stations.

The station occupying a channel is erased if another station is preset in that channel.

To listen to preset channels

1Press [TUNER/BAND] to select “FM” or “AM”.

2Press [TUNE MODE] to display

“”.

3Press [– / ] or [ / +] to

select the desired channel. (FM:1-20, AM:1-12)

Preset channel

3

RQTT0622