Panasonic RX-D26 manual CDs, Normal play, Program play, CD play modes

Adjust the volume.

CDs

Normal play

3 12 4

1 Push [ CD OPEN/CLOSE] to

Program play

You can program up to 24 tracks.

13 2 4

Ensure CD is stopped before programming.

open the CD lid and insert the CD.

Label must face upward.

2	Push [ CD OPEN/CLOSE] to
	close the CD lid.

3	Press [CD / ] to start play.		Elapsed play time
	(Unit comes on.)
	Play starts from the first track and
	continues to the last track.	Track	number in play

1

2

3

Press and hold [–PGM].

While “ ” is flashing

Press [–/] or [/+] to select the desired track.

Press [–PGM].

The track is programmed.

Play time

Track number

Program order

4

To stop play

Press [ / CLEAR].

While stopped, the number of tracks on the CD is displayed.

Total playing time

			Total number of tracks
To pause	Press [CD	/	] during playback.
	To resume, press [CD /			].
To search forward/	Hold down [− /		] (backward) or [			/+ ]
backward	(forward) during playback or when paused.
To skip forward/	Press [− /	] (backward) or [			/+ ] (forward)
backward	during playback or when paused.

“NO DISC” is displayed if there is no disc in the unit.

Note

•If interference occurs to radios or televisions, place the unit as far as possible from the equipment.

• Do not press [ CD OPEN/CLOSE] during play, pause or immediately after you inserted the CD and closed the CD lid. CD may be scratched.

This unit can play CD-DA (digital audio) format audio CD-R and CD- RW that have been finalized (a process that enables CD-R/CD-RW players to play audio CD-R and CD-RW) upon completion of recording.

It may not be able to play some CD-R or CD-RW due to the condition of the recording.

Specified track number

Repeat steps 2 and 3 until you have programmed all the tracks you want.

Total play time of programmed tracks

4 Press [CD / ].

To cancel program play mode

Press [ /CLEAR] while stopped. “CLEAR” is displayed. The mode is also canceled if the CD tray is opened. This will also erase the entire program.

To check program contents

“P” appears in the display when play is stopped. Press [–/ ] or [ /+] when “P” is displayed.

To check while programming press [ / CLEAR] and after “P” appears, press [–/ ] or [ /+].

Display

“—— :— —” : Program equals, or exceeds, 100 minutes but programming and play are still possible.

“FULL”: 24 tracks have already been programmed. The program is full.

CD play modes

Preparations:
Press [CD /		] and then [	/ CLEAR] to switch to CD mode.
You can repeat one track (			), all tracks (	) or play the tracks in
random order (	).

Press [•CD PLAY MODE] to select the desired mode.

off (no indication)

These modes remain active until the indicators are cleared. You can use repeat mode with program play.

Note

•During play, you cannot select random play.

•Random and program play cannot be performed at the same time.

4

RQTT0622