Panasonic Section 520 manual Programming the DBS, = Standard API protocol default

Chapter 3. Installation Section 520 - TSAPI

Programming the DBS

1.Enter the DBS programming mode

2.Set the API port to Telephony Services as follows:.

Program	API Port Type
Name
Address	FF1 2# 1# (41 or 42)# 1# (0-1)#
	API Port Number	Port Type:
	41 = Port 1	0	= Standard API protocol (default)
	42 = Port 2	1	= Telephony Services protocol

Note: The Telephony Services NLM defaults to use the first port (41).

3.Set the Telephony Services API Port Baud rate to the desired baud rate as follows:.

Program	API Baud Rate
Name
Address	FF1 2# 1# (41 or 42)# 2# (0-1)#
	API Port Number	Baud Rate:
	41 = Port 1	0 = 9600	(default)
	42 = Port 2	1 = 19200

Note: If Telephony Services is the only connection to the API card, it is recommended that the baud rate be set to19200. If both API ports are used, it is recommended that both baud rates be set to 9600 bps.

8 Issued April 2000 DBS-92-520