Panasonic CY-BT100U operating instructions Advanced Operation, Disconnection, Reconnection

Page 21

Advanced Operation

English

Calling back

A call-back call can be made.

However, the callback function is disabled after disconnecting Bluetooth communication. (e.g. communication disconnection between the Bluetooth unit and mobile phone, and communica- tion disconnection by turning off the power of the Head unit)

Step 1

Press the [Hang-on]after a call comes in.

Step 2

Confirm the telephone number on the Head unit.

Step 3

Press the [Hang-on]to make a call.

(Press [Hang-up]to activate cancellation.)

Note: Some mobile phones cannot display the telephone num- ber of an incoming call or call back.

Rejection of incoming calls

Press the [Hang-up]to reject an incoming call.

Disconnection of Bluetooth

You can disconnect Bluetooth temporarily.

Disconnection

Press and hold the [Hang-up]. for more than 2 seconds until the indicator putting out (approximately 2 seconds ) to reject call on this unit.

Reconnection

Press [Hang-on]. The LED turns from blinking to perma- nent.

Note: You cannot disconnect Bluetooth in the talking state but end a call.

21

Image 21
Contents CY-BT100U Comply with regulations Safety InformationKeep away from the medical devices DeathDo not use the unit when it is out of order Use the proper power supply 12Stop using this unit and mobile phone whenever requested Do not disassemble or modify the unitSafety Information Take care not to damage the leads Follow the instructions to install and wire the prod- uctSafety Information FCC Warning Accessory Purchases Customer Services DirectoryService in Puerto Rico Npcparts@panasonic.comVancouver Toronto Panasonic Factory ServicePanasonic Auto Products Limited Warranty Limited WarrantyPanasonic Product Limited Warranty Components Contents This unit does not support the voice dial function IntroductionInstallation sample Glossary Switch Unit Status indicator Blue LEDSystem-up connector Names of Controls and FunctionsPreparation PairingCommunication test on paired mobile phone Receiving a call Basic OperationAdvanced Operation DisconnectionReconnection Installation Switch Unit w Main Unit q Wiring Direct Cable for iPod CA-DC300U, Option IPod Expansion ModuleTroubleshooting If You Suspect Something WrongPaired mobile phone cannot be automatically reconnected There is the other wireless equipment near the unit Turn on the power of the head unit Telephone conversation should be conducted alternately Call-back call cannot be made Connect the Switch Unit securely and properly Specifications FCC IDACJ932CY-BT100U YFM284C529ZA PTW1105-1115
Related manuals
Manual 92 pages 37.7 Kb