Belkin F1PG200ENAU user manual Troubleshooting

Page 13

Troubleshooting

Problem:

The Phone Adapter cannot connect to the router..

The “connected” light does not come on..

Solution:

If your Phone Adapter appears to be powered but the “connected” light is not green, the problem may be that your router and Phone Adapter are not connected properly..

Make sure the network cable between the router and the Phone Adapter is connected to the Phone Adapter’s “Connection to Router” port and that the cable is firmly in place.. Power off the router for a few seconds and then power it on again..

1

2

3

4

5

6

section

11

Image 13
Contents IiNet ATA Telephone Adapter Table of Contents Introduction Product Overview Key FeaturesBuilt-In Dynamic Host Configuration Protocol Dhcp Client Knowing your Phone Adapter Package ContentsSystem Requirements Product Specifications Resetting the Phone Adapter Reset SwitchRestoring the Factory Defaults Phone PortsConnected LED Power JackPhone LED Determining your Current Network and Connection Connecting and Configuring your Phone AdapterConnecting your Phone Adapter to a Gateway/Router Problem TroubleshootingSolution Troubleshooting Technical Support TroubleshootingFCC Statement InformationFederal Communications Commission Notice Canada-Industry Canada IC ModificationsEurope-European Union Notice Belkin Corporation Limited 2-Year Product Warranty ATA Hardware Setup