Belkin F1PG200ENAU Information, FCC Statement, Federal Communications Commission Notice

Page 15

Information

FCC Statement

DECLARATION OF CONFORMITY WITH FCC RULES FOR

ELECTROMAGNETIC COMPATIBILITY

We, Belkin Corporation, of 501 West Walnut Street, Compton, CA 90220, declare under our sole responsibility that the product,

F1PG200ENau

to which this declaration relates, complies with Part 15 of the FCC Rules.. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation..

Caution: Exposure to Radio Frequency Radiation.

The radiated output power of this device is far below the FCC radio frequency exposure limits.. Nevertheless, the device shall be used in such a manner that the potential for human contact during normal operation is minimized.. When connecting an external antenna to the device, the antenna shall be placed in such a manner to minimize the potential for human contact during normal operation.. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation..

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.. These limits are designed to provide reasonable protection against harmful interference in a residential installation.. This equipment generates, uses, and can radiate radio frequency energy.. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna..

Increase the distance between the equipment and the receiver..

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected..

Consult the dealer or an experienced radio/TV technician for help..

1

2

3

4

5

6

section

13

Image 15
Contents IiNet ATA Telephone Adapter Table of Contents Introduction Product Overview Key FeaturesBuilt-In Dynamic Host Configuration Protocol Dhcp Client Package Contents Knowing your Phone AdapterSystem Requirements Product Specifications Phone Ports Reset SwitchResetting the Phone Adapter Restoring the Factory DefaultsPower Jack Connected LEDPhone LED Determining your Current Network and Connection Connecting and Configuring your Phone AdapterConnecting your Phone Adapter to a Gateway/Router Troubleshooting Problem Solution Troubleshooting Technical Support TroubleshootingInformation FCC StatementFederal Communications Commission Notice Modifications Canada-Industry Canada ICEurope-European Union Notice Belkin Corporation Limited 2-Year Product Warranty ATA Hardware Setup