Configuring and Troubleshooting an ATA 186 with Cisco IOS Gatekeepers
Document ID: 19084
Introduction
Prerequisites
Requirements
Components Used
Conventions
Network Diagram
Registering the ATA 186 with the Gatekeeper
Adding Security
Authenticate the Endpoint at the Gatekeeper with an H.323 ID Authenticate the Endpoint at the Gatekeeper with an E.164 Address Authenticate the Endpoint at the Gatekeeper with an H.323 ID and Password Authenticate the Endpoint at the Gatekeeper with an E.164 Address and Password Authenticate the Endpoint at the Gatekeeper with an H.323 ID and Password Using the
Separator
Verify
Troubleshoot
Troubleshoot the Gatekeeper
Troubleshoot the ATA 186
Sample Debugs for Calls Made from the ATA 186
NetPro Discussion Forums − Featured Conversations
Related Information
Introduction
The Cisco Analog Telephone Adaptor (ATA) 186 is a handset−to−Ethernet adaptor that interfaces regular analog phones with IP−based telephony networks. The ATA 186 has two voice ports that can only support legacy analog touch tone telephones. Unlike the regular Foreign Exchange Station (FXS) ports, these can not be interfaced with a private branch exchange (PBX) because the ATA 186 can not send out digits on these ports. With this configuration, you can use both voice ports with different E.164 addresses on each.
Prerequisites
Requirements
This document assumes that the reader is familiar with the content in the Cisco ATA 186 Basic Configuration document.
This configuration requires ATA 186 to be at version 2.0 or later, using the H.323 feature set.
Ensure that there is IP connectivity between the ATA 186, gateway, and gatekeeper devices. Also, ensure that the ATA 186 is accessible through the web server method for further configuration.