Transmitting a Call Tone, Keylock ON/OFF

UT928ZH_UH060_ENG_0929 9/29/04 3:26 PM Page 10

The current selected VOX setting will flash on the display.

Press volume/channel ▲ or ▼ key to adjust the VOX sensitivity. 1 is the highest sensitivity and 4 is the lowest sensitivity. VOX can be turned off by selecting ‘oF’ icon.

The ‘VOX’ icon is shown on the display when VOX is selected to on and VOX Headset is plugged into VOX Headset Jack. The ‘TX’ icon blinks when the voice level is possible to transmit at the current selected VOX sensitivity level.

Press select/power key twice to confirm the setting and exit to standby mode.

TRANSMITTING A CALL TONE

Your UH060SX-2 radio is equipped with 5 selectable call tones that will be transmitted when the dup/call key is pressed and held for 3 seconds.

To select a call tone:

1.Press select/power key momentaly twice while in standby mode to enter Call Tone mode. The current call tone number (C1-C5) will be indicated.

2.Press the volume/channel ▲ or ▼ key to increase or decrease the number to the desired call tone. Each tone will be heard through the speaker.

3.Press select/power key to confirm and exit to standby mode.

To transmit the selected call tone, press and hold the dup/call key. The selected tone will automatically be transmitted for a fixed length of time. Call Tone will be cancelled when the PTT button is pressed.

KEYLOCK ON/OFF

Press ch/vol/keylock key for 3 seconds to enter keylock on mode.

Press ch/vol/keylock key for 3 seconds while in Keylock mode to exit the Keylock mode.

While in Keylock on mode, the UH060SX-2 can still receive and transmit.