Uniden DS845 quick start Travelling OUT of Range, KEY Lock / Unlock, Call WAITING/FLASH

Page 15

NOTE

Only the last number dialed can be accessed after talk has been pressed.

Press redial/p again

REDIAL 3

95983577

3rd ‘most recent number dialed’ is displayed.

4. Press talk and the number will be dialed.

Redial from talk mode

1.Press talk

2.Press redial/p - the last number dialed will be displayed and redialed.

TALK LOUD 1

TALK LOUD 1 95979035

!

Only numbers dialed from the Base Unit keypad will be redialed from the Base redial key.

Redial from the Base Unit

1.	To call the last number dialed from the Base Unit, press speaker .
2.	Press redial/p - the last number dialed will be redialed.
3.	To hang up, press speaker .

TRAVELLING OUT OF RANGE

During a call, noise will increase if you move your handset too far from your base unit. If the range limit of your base unit is exceeded, your call will terminate within 30 seconds.

KEY LOCK / UNLOCK

When the handset is in the ST/BY mode, press	KEY LOCKED
When the handset is in the ST/BY mode, press
and hold flash/reg , a beep confirms and
the screen displays KEY LOCKED
During the ‘Key Locked’ condition, the
buttons will only operate on an incoming call.	KEY UNLOCKED
To unlock the keys, press and hold flash/reg
again.

CALL WAITING/FLASH

If the Call Waiting tone sounds during a call -

Australia: Press flash/reg , then 2 to switch between callers.

New Zealand: Press flash/reg to switch between callers.

9

Image 15

Contents Quick Start Guide Precautions AC Adaptor cord AC Adaptor into Raise the antenna StartMake sure the plug is the right way round Press firmly until it clicks into placeIii Remove the handset from the base and speak Auto Talk To hang up press talkPlace the handset on the base Unit Handset on Base UnitDelete all messages After reviewing all messages press Press new messages play firstPress during playback of messages Delete one messageContents Controls & Functions Rear of Base Unit Top of Base Unit Latest in 900 MHz Digital Spread Spectrum Technology WelcomeYour place of purchase Belt ClipCard If any of these items areRinger tone and volume Battery use time per chargeWhen the battery charge becomes low Cleaning the battery contactsTo answer a call phone ringing Making and Receiving CallsBasic phone operation Talk buttonTo transfer from base unit to handset Call TransferRedialling a Call To transfer from handset to base unitTravelling OUT of Range KEY Lock / UnlockCall WAITING/FLASH Storing Phone Numbers and Names With the HandsetWith the Base Unit Memory Dialing from the Base Unit Memory dialing from talk modeMemory Dialling from Standby Display a Memory Number or NameScreen displays You would like to editPress select the confirmation screen is displayed Erasing a Stored Number from the Base UnitMemory location you would like to edit Press to move the pointer down toPAGING/INTERCOM Way radio feature using an optional handsetPress flash/reg on the handset Fig Different number to enable functions such as Call TransferRegistration Remove the handset from its chargerWhen the Telephone Rings Caller IDName tagging Viewing the Caller ID Message List Deleting Information from the Caller ID ListDeleting all Caller ID names/numbers Using the Caller ID List Calling a party from the Caller ID listStoring Caller ID messages in Memory dialing Features Setting Up Your Answering SystemAnswer System Using Your Answering System Deleting Messages Then Remote access away from homeRemote room monitor Call your telephone numberTrouble Shooting Uniden Australia Pty Limited A.B.N 001 865 One Year Limited WarrantyWarrantor Uniden New Zealand LimitedPage Uniden Australia Pty Limited Uniden New Zealand Limited