Icom iF25 S instruction manual Battery Charging, Battery charging, Recommendation

Page 13

5 BATTERY CHARGING

Battery charging

Prior to using the transceiver for the first time, the battery pack must be fully charged for optimum life and operation.

CAUTION: To avoid damage to the transceiver, turn it OFF while charging.

Recommended temperature range for charging:

+10°C to +40°C

- The Li-Ion battery functions within –20°C to +60°C

Use the specified chargers (BC-119N, BC-121N and BC-160). NEVER use another manufacturer’s charger.

Use the optional AC adapter. NEVER use another manufacturer’s AC adapter.

Recommendation:

Charge the supplied battery pack for a maximum of up to 10 hours. Li-Ion batteries are different from Ni-Cd batteries in that it is not necessary to completely charge and discharge them to prolong the battery life. Therefore, charging the battery in in- tervals, and not for extended periods is recommended.

BATTERY CHARGING 5

Caution

RDANGER Charge the specified Icom batteries only.

Only tested and approved for use with genuine Icom batteries. Fire and/or explosion may occur when a third party battery pack or counterfeit product is charged.

CAUTION! NEVER insert battery pack/transceiver (with the bat- 5 tery pack attached) with wet or soiled into the charger. This may re- sult in corrosion of the charger terminals or damage to the charger. The charger is not waterproof and water can easily get into it.

NEVER incinerate used battery packs. Internal battery gas may cause an explosion.

NEVER immerse the battery pack in water. If the battery pack be- comes wet, be sure to wipe it dry immediately (particularly the bat- tery terminals) BEFORE attaching it to the transceiver. Otherwise, the terminals will become corroded, or cause connection failure, etc.

NEVER short the terminals of the battery pack. Also, current may flow into nearby metal objects, such as a necklace, etc. Therefore, be careful when carrying with, or placing near metal objects, carry- ing in handbags, etc.

AVOID leaving the battery pack in a fully charged, or completely discharged condition for long time. It causes shorter battery life. In case of leaving the battery pack unused for a long time, it must be kept safely after discharge, or use the battery until the battery indi- cator appears, then remove it from the transceiver.

If your battery pack seems to have no capacity even after being charged, fully charge the battery pack again. If the battery pack still does not retain a charge (or very little), a new battery pack must be purchased.

20

21

Image 13
Contents IF15/S Foreword Table of Contents Battery pack Accessory attachmentsTo attach the battery pack To release the battery packTo attach the belt clip Jack cover Belt clipTo detach the belt clip Front, top and side panels Panel DescriptionWhen the power on scan function is turned OFF ‘ LED indicatorWhen the power on scan function is turned on ‘ Programmable function keysDtmf Autodial KEY Call procedure Turning power onConventional Operation Channel selectionTransmitting notes Receiving and transmittingDtmf transmission Scrambler function Setting the squelch levelMan Down Emergency Call UpperScrambler unit installation Optional unit installationBattery charging Battery ChargingRecommendation AD-106 installation Optional battery chargersRapid charging with the BC-160 Rapid charging with the BC-121N+AD-106 Rapid charging with the BC-119N+AD-106Swivel Belt Clip MB-93 contentsTo attach To detach UT-109 #01/UT-110 #01 Scrambler Units Options0168 DOCMemo Intended Country of Use