Channel can
In the scan mode, the radio alternately monitors each Channel until it receives a call. You can scan all Channels, or you can temporarily lock out individual Channels from scanning as desired.
1.Press Sto begin scanning. The SCAN indicator begins to flash.
08 SCAN |
2.The radio stops on any Channel that receives a call, and you hear the caller. When the transmission stops, the radio resumes scanning after a brief delay.
3.To disable scanning, press S.
Dual Watch
If your radio has been programmed with a Priority Channel, the radio will sample the Priority Channel between any other receiving Channel during Scan Mode. This is usually the Channel you use for most of your communications.
During scan the PRI indicator will flash whenever the Priority Channel is being monitored.
PRI 05 SCAN |
Create a Channel Scan List with Channel Lock Out
Deleting channels (from the channel scan list) increases the scanning speed.
Use <or >to select the desiredLchannel and press
. The
03 DEL
To remove the
Drop Out Delay
While scanning, the radio stops at a busy channel and receives a transmission. When the received call is over, it resumes scanning after a short delay (programmable).
Transmit
1.Use <or >to select the desired channel.
2.Before you transmit, press Mand listen for activity on the channel. Also check the Transmit/Receive Indicator. If it is blinking RED, the Channel is locked out, and you cannot transmit.
- 13 -