Installing/removing the belt clip
The supplied belt clip allows you to hang the transceiver on your belt or jacket when you are not using the radio.
1SLIDE DOWN
PUSH
To fit the belt clip onto the transceiver’s body:
1)Gently slide the clip into the appropriate guides located on the transceiver’s battery pack until it firmly locks.
To remove the belt clip:
2) Gently move the latch located between the top |
LIFT UP
2
3
of the belt clip and the battery pack towards the |
belt clip |
3) Slide the belt clip off the radio. |
Charging the battery pack
To charge the supplied battery pack you have to setup the charger and connect the radio as follows:
1)Connect the jack coming from the AC adapter to the cradle’s socket.
3)Connect the AC plug of the AC adapter’s power cable into a grounded AC power outlet.
4)Ensure that the radio is switched off.
5)Insert the radio into the cradle with the keypad toward you (the three metallic contacts of the battery pack must touch with the three contacts inside the cradle).
6)Wait
Do not remove the radio before the specified time, otherwise the battery’s duty could be temporarily reduced.
,Do not forget to remove the radio from slow charger after 10 to 12 hours.
,The battery charger is for indoor use only.
,For the next charges, best duty and battery life please see the chapter “Battery Packs”.
Page. 11