Cobra Electronics CXT225 Caring for Your microTALK Radio, Rechargeable Batteries and Charger

Page 3

 

 

 

 

 

 

 

Introduction

Operation

Customer Assistance

Warranty

 

Caring for Your microTALK® Radio

Your microTALK® radio will give you years of trouble-free service

if cared for properly. Handle the radio gently. Keep the radio away from dust. Never put the radio in water or in a damp place. Avoid exposure to extreme temperatures.

Rechargeable Batteries and Charger

Remove Belt Clip

To install or replace batteries:

 

1. Remove belt clip by releasing belt clip

 

latch and sliding clip up.

Pull Up Lock Latch

2. Pull up on the battery door latch to remove the battery compartment cover.

Insert Batteries

Radio Charger Jack

3.Insert the supplied four AAA rechargeable batteries or non-rechargeable alkaline batteries. Position batteries according to polarity markings.

4.Replace battery compartment cover and belt clip.

To charge batteries in radio:

1.Check to see that the batteries have been inserted properly.

2.Insert the wall charger/adapter into the charge jack located at the top of the radio. The wall charger/adapter has two round connectors which enables you to charge either one or two radios at a time.

3.Plug the wall charger/adapter into electrical outlet.

It normally takes 15 hours to fully recharge batteries. It is not recommended to recharge batteries more than 24 hours. Estimated operation time on a full charge is 8 hours.

Use only the supplied rechargeable batteries and wall charger/adapter for recharging your Cobra microTALK® radio.

Nothing Comes Close to a Cobra® 1

Image 3
Contents Making Life Easier and Safer Product Features Warranty and Trademark AcknowledgementLimited One-Year Warranty on Radios & Charger Check to see that the batteries have been inserted properly Replace battery compartment cover and belt clipCaring for Your microTALK Radio Rechargeable Batteries and ChargerUsing Your Radio Lock Function To Adjust VolumeListening for a Response Call ButtonScrolling Through the Mode Function Set Ctcss Privacy CodesPrivacy Codes Mode Functions Set DCS Privacy CodesVoice Activated Transmit VOX Channel Scan During scanning, you last transmitted or received Press the Mode/Power button to proceed to other functionsRoger Beep Confirmation Tone Press and hold the Talk button to communicate onGeneral Specifications General Specifications and LicensingProduct Service Product Service QuestionsSend the entire product