Cobra Electronics CXT225 owner manual Channel Scan

Page 8
Privacy Code Scan

Mode Functions

Operation

Channel Scan

Your microTALK® radio can automatically scan channels.

Mode/Power

To scan channels:

 

1. Press the Mode/Power button until the

 

Scan icon and the channel numbers appear

 

on the display.

 

 

 

 

Introduction

Operation

Customer Assistance

Warranty

During scanning (while not receiving a transmission), you can choose from the following:

a. Press and hold the Talk button to communicate on the channel or channel/privacy code that was displayed before you entered mode functions or the channel on which, during scanning, you last received a transmission.

This will return the radio to Standby mode.

Scan Channels

Channel Button

2.Press the Channel Up or Channel Down button to begin scanning channels.

The radio ignores specific privacy codes while scanning channels.

The Scan icon will continue to be displayed when scan is on. Your radio will continue to scan all channels and stop if an incoming transmission is detected. Your radio will remain on that channel for 10 seconds.

b. Press the Mode/Power button to proceed to set privacy code scan on the channel that was either displayed before

you entered mode functions or on which, during channel scanning, you last received a transmission (see page 12

for further details).

c. Press the Lock button to return to Standby mode on the channel/privacy code that was displayed before you entered mode functions or the channel on which, during scanning,

you last transmitted or received.

While setting channel scan, if you do not press any buttons for 15 seconds your radio will automatically return to Standby mode on the channel or channel/privacy code displayed before you entered mode functions.

During scanning (while receiving an incoming transmission), you can choose from the following:

a. Press and hold the Talk button to communicate on that channel. Your radio will remain on that channel and return to Standby mode.

b. Press the Channel Up or Channel Down button to resume scanning channels.

Your microTALK radio can automatically scan the Privacy Codes (either CTCSS 01 through 38 or DCS 01 through 83) within one channel. Only one set of privacy codes (CTCSS or DCS) can be scanned at a time.

To scan privacy codes:

Sel

e

ct Channel

1. While in Standby mode, press the

 

 

 

Channel Up or Channel Down button

 

 

 

to choose the channel on which you

 

 

 

wish to scan privacy codes.

If you press the Talk button while scanning and not within 10 seconds of receiving a transmission, you will transmit on the channel on which you last received a transmission. This will return the radio to Standby mode.

If you do not press any button within 10 seconds, your radio will automatically resume scanning channels.

Mode/Power

Scan Privacy Codes

2.Press the Mode/Power button until either the CTCSS or the DCS icon appears on the display and the Scan icon and the privacy code numbers flash on the display.

3.Press the Channel Up or Channel Down button to begin scanning privacy codes

within the channel you selected.

10

Channel Button

Nothing Comes Close to a Cobra® 11

Image 8
Contents Making Life Easier and Safer Limited One-Year Warranty on Radios & Charger Product FeaturesWarranty and Trademark Acknowledgement Replace battery compartment cover and belt clip Caring for Your microTALK RadioRechargeable Batteries and Charger Check to see that the batteries have been inserted properlyUsing Your Radio To Adjust Volume Listening for a ResponseCall Button Lock FunctionPrivacy Codes Scrolling Through the Mode FunctionSet Ctcss Privacy Codes Voice Activated Transmit VOX Mode FunctionsSet DCS Privacy Codes Channel Scan Press the Mode/Power button to proceed to other functions Roger Beep Confirmation TonePress and hold the Talk button to communicate on During scanning, you last transmitted or receivedGeneral Specifications and Licensing General SpecificationsSend the entire product Product ServiceProduct Service Questions