Introduction
Using Your Radio
Introduction | Operation | Customer Assistance Warranty |
| Turning on Your microTALK® Radio |
Insert Radio(s) | For charging microTALK® radio(s) in desktop | |
| charger: | |
| 1. | Insert radio(s) into desktop charger as shown. |
| 2. | Insert round connector of |
|
| into jack on back of charger. |
| 3. | Plug |
| If charging light is not on, check position of radio. | |
| Radio should be upright. The charge | |
indicator light will stay on as long as the radio is in the charging |
well and the battery pack is charging. After the battery pack is fully charged, the charge indicator light will turn off.
It normally takes about 15 hours to fully recharge battery pack. Battery pack will not be damaged if it stays in the charging well longer than that.
To charge a single radio, you can bypass the desktop charger and simply insert the wall adapter’s round connector directly into the speaker/microphone/charge jack located on the top of the radio.
Use only the supplied rechargeable batteries and charger for recharging your Cobra microTALK® radio.
Cobra recommends your radio is turned off while being charged.
Quick Start
1. Press and hold the Power button to turn on your radio.
2.Press the Channel Up or Channel Down button to select a channel.
Both radios must be tuned to the same channel/privacy code to communicate.
3.Press and hold the Talk button while speaking into the microphone.
4.When finished talking, release the Talk button and listen for a response.
2
On/Off Power | Press and hold the Power button until you | • |
|
| |
| hear a series of audible tones indicating the |
|
| radio is on. |
|
Battery Low
•
Battery Save Mode
Talk Button | Communicating with Another Person | • | |
| 1. | Press and hold the Talk button. |
|
| 2. | With the microphone about 2 inches |
|
|
| (5 cm) from your mouth, speak in a |
|
|
| normal voice. |
|
Two Inches (5 cm) from Mouth
3