Cobra Electronics CXR800C owner manual VibrAlert and Call Alert, To change call settings

Page 14

Operation

Mode Functions

 

 

 

 

 

 

 

Introduction

Operation

Customer Assistance

Warranty

 

During memory location scan (while receiving an Incoming transmission), you can choose from the following:

a. Press and hold the Talk button to communicate on that

VibrAlert and Call Alert

•

Your microTALK radio can alert you to incoming signals by sounding an audible call tone, by vibrating silently or both.

memory location.

b. Your radio will remain on that memory location and return to Standby mode. Press the Channel Up or ChannelDown button to resume scanning memory locations.

c. After 10 seconds of inactivity, unit starts scan again.

If you press the Talk button while scanning, but more than

10 seconds after receiving a transmission, you will transmit on the memory location on which, during scanning, you last received a transmission.

If you do not press any button within 10 seconds, your radio will automatically resume scanning memory locations.

Mode Button

Channel Button

To change call settings:

1.Press the Mode button until the Call Setting icon flashes on the display. The current setting (“01” vibrate + ring, “02” vibrate only or “03” ring only)

is displayed.

2.Press the ChannelUp or ChannelDown button to change the call setting.

3.Choose one of the following:

VibrAlert + Ring

VibrAlert Only

Ring Only

During memory location scan (while not receiving a transmission), you can choose from the following:

a. Press and hold the Talk button to communicate on the channel/privacy code that was displayed before you entered mode functions or memory location on which, during scanning, you last received a transmission.

b. Press the Mode button to proceed to other functions.

c. Press the Lock/Enter button to return to Standby mode on the channel/privacy code that was displayed before you entered mode functions or the memory location on which, during scanning, you last received a transmission.

To reduce the number of memory locations being scanned, you may de-program any unwanted locations. (See page 16 to de-program a memory location.)

a. Press the Mode button to enter the new setting and proceed to other functions.

b. Press the Lock/Enter button to enter the new setting and return to Standby mode.

 

 

 

 

22 English

Nothing Comes Close to a Cobra® 23

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Customer Assistance Operators Making Life Easier and SaferAutomated Help Desk QuestionsProduct Features Features ChannelsReplace battery compartment cover and belt clip Rechargeable Battery Pack and Desktop ChargerTo install or replace battery pack Caring for YourmicroTALKRadioAuto Battery Save Using Your RadioBattery Low Communicating with Another PersonCall Button To switch from high to medium to low powerListening for a Response To alert another person that you are callingTo turn maximum range extender on To turn the lock feature on or offLight/Max Range To briefly turn off auto squelch To attach a speaker/microphonePrivacy Codes Mode FunctionsScrolling through Mode Functions Set Ctcss Privacy CodesTo select a DCS privacy code Standby modeSet DCS Privacy Codes NOAA* All Hazards Radio ChannelsTo program a memory location To turn VOX mode on or offPress the Mode button until Flash on the displayTo recall a stored memory channel location Press the Mode button toChoose one of the following Display Through To de-program a memory location Channel Scan To scan channelsPrivacy Code Scan Press the Mode button to proceed to set privacyPress the Channel Up or Channel Down button to Select Channel To scan privacy codesMemory Location Scan To scan memory locationsTo change call settings VibrAlert and Call AlertTo turn roger beep on or off To change a call tone settingTo change keystroke tones General Specifications FCC License General SpecificationsProduct Service Product ServiceSafety and Trademark Acknowledgement Safety Information for microTALK RadiosWarranty Limited One-Year Warrantyon Radios& Charger
Top Page Image Contents