Cobra Electronics PR260 WX Caring for Your microTALK Radio, To charge batteries in radio

Page 5

Introduction

Operation

Customer Assistance Warranty

Caring for Your microTALK® Radio

Your microTALK® radio will give you years of trouble-free service if cared for properly. Handle the radio gently. Keep the radio away from dust. Never put the radio in water or in a damp place. Avoid exposure to extreme temperatures.

Remove Belt Clip

Rechargeable Batteries and Charger

To install or replace batteries:

Pull Up Lock Latch

Insert Batteries

1.Release belt clip and pull up.

2.Press the battery door latch to

remove the battery compartment cover.

3.Insert the supplied four (4) AAA rechargeable batteries or non-rechargeable alkaline batteries. Position batteries according to polarity markings.

4.Replace battery compartment cover and belt clip.

Radio Charger Jack

To charge batteries in radio:

1.Check to see that the batteries have been inserted properly.

2.Insert the wall charger/adapter into the charge jack located at the top of the radio. The wall charger/adapter has two round connectors which enables you to charge either one or two radios at a time.

3.Plug the wall charger/adapter into electrical outlet.

It normally takes 15 hours to fully recharge batteries. It is not recommended to recharge batteries more than 24 hours. Estimated operation time on a full charge is 8 hours.

Use only the supplied rechargeable batteries and wall charger/adapter for recharging your Cobra microTALK® radio.

1

Image 5
Contents PR260 WX Automated Help Desk Making Life Easier and SaferCustomer Assistance Operators QuestionsProduct Features 117 FeaturesCaring for Your microTALK Radio Replace battery compartment cover and belt clipTo charge batteries in radio Check to see that the batteries have been inserted properlyTo connect a wall charger/adapter Using Your RadioSpeaker/Microphone/Charge Jack Communicating with Another Person Auto Battery SaveTo Select a Channel To Adjust Volume Press the Volume Up or VolumeListening for a Response Call ButtonTo turn maximum range extender on Light/Max Range To temporarily turn off auto squelchTo turn maximum range extender off To turn the lock on or offMicroTALK Range Scrolling Through the Mode FunctionYour range will vary depending on terrain and conditions Set Privacy CodeTo select a privacy code Ctcss Privacy CodesTo turn VOX mode on or off Mode FunctionsNOAA* All Hazards Radio Channels To listen to all hazards radio channelsTo scan channels To Set VOX SensitivityChannel Scan This will return the radio to Standby mode To scan privacy codes Privacy Code ScanIf you press the Talk button while scanning and not within Press the Mode/Power button to proceed to other functionsTo change a call tone setting Five Call Tone SettingsRoger Beep Confirmation Tone To turn roger beep on or offGeneral Specifications General Specifications and LicensingImportant Notice FCC License Required Product Service Questions Product ServiceLimited One-Year Warranty on Radios & Charger Warranty and Trademark AcknowledgementEnglish