OPER ATIO N |
| English |
Charger and Rechargeable Batteries | Remove Belt Clip Lock Tab | Insert Batteries |
To Insert Batteries in Radio:
1. Remove belt clip by releasing belt clip latch and sliding clip up.
2. Push up on lock tab to remove battery cover.
3. Insert batteries according to polarity markings.
NOTE: Estimated operation time on full charge: 12 hours.
These rechargeable batteries must be recycled or disposed of properly in compliance with all applicable laws. They must not be thrown in the rubbish bin. Some countries and local authorities require recycling and have established collection programs. Please contact your local waste disposal authority for instructions.
WARNING: Do not put batteries into fire or expose to high heat. They may explode.
Wall Charger
Insert Connector
For Charging Cobra’s microTALK® Radio(s):
1.Check to see that the batteries have been inserted properly. See above for battery installation instructions.
2.Insert round connector of wall charger into the charge jack located at the top of the radio. The wall charger has two (2) round connectors which enables you to charge either one (1) or two (2) radios at a time.
3.Plug the wall charger into electrical outlet.
It is not recommended to recharge batteries more than 24 hours. Estimated operation time on a full charge is 12 hours.
Use only the supplied rechargeable batteries and wall charger for recharging your Cobra microTALK® radio.
Radio Power
To Turn Your Radio On:
– Press and hold the MODE/POWER button until you hear a series of audible tones indicating that the radio is On.
Your microTALK® radio is now in LISTENING MODE, ready to receive transmissions. The radio is always in LISTENING MODE, except when the TALK, CALL or MODE/POWER buttons are pressed.
To Turn Your Radio Off:
– Press and hold the MODE/POWER button for two (2) seconds.
Battery Low Indicator
When battery power is low, the BATTERY LOW indicator will blink, indicatingthat batteriesshould be recharged or replaced.
WARNING: Only the supplied NiMH batteries can be recharged.
Battery/Power Saver
Mode/Power
Button
Battery Low Icon
Power Saver Icon
If there are no transmissions within 10 seconds, the unit will automatically switch to Battery Save mode and POWER SAVER will appear in the display. This will not affect the unit’s ability to receive incoming transmissions.