Using Your Radio
Operation
Speaker/Microphone Jack
•
Your microTALK® radio can be fitted with an external Speaker/ Microphone, freeing your hands for other tasks. Contact your local Cobra® dealer or Cobra® directly for optional accessories. Only Cobra® authorized accessories are recommended.
Speaker/Microphone To Attach Your Speaker/Microphone:
1.Open the speaker/microphone tab on top of your microTALK® radio.
2.Insert the plug into the speaker/ microphone jack.
microTALK® Range
•
Your microTALK® radio has a range of up to six (6) miles [ten
(10) km]. Your range will vary depending on terrain and conditions.
|
|
|
|
Introduction | Operation | Customer Assistance | Warranty |
Scrolling Through the Mode Function
•
By scrolling through the Mode function, you will be able to select or turn On preferred features of your microTALK® radio. When scrolling through the Mode function, your radio features will be displayed in the same predetermined order:
Mode/Power Button |
|
| Set Privacy Code |
|
| ||
|
|
| Set Channel Scan |
|
|
| Set Privacy Code Scan |
|
|
| Set Call Tones |
|
|
| Set Roger Beep On/Off |
|
CTCSS Privacy Codes
•
CTCSS (Continuous Tone Coded Squelch System) is an advanced tone coding system allowing you to select one of 38 privacy codes to reduce interference from other users on the channel.
Maximum Range
Reduced Range
In flat, open country your radio will operate at maximum range.
Buildings and foliage in the path of the signal can reduce the range of the radio.
Dense foliage and hilly terrain will further reduce
If you are using a privacy code, both radios must be tuned to the same channel and privacy code to communicate. Each channel will remember the last privacy code you selected.
Reduced Range
the range of the radio.
On FRS Channels 8 through 14, your radio automatically switches to low power, which will limit the range the radio can communicate.
Remember, you can achieve maximum range by using maximum range extender. See page 5 for details.
Mode/Power Button
Privacy Code
Channel Button
To Select A Privacy Code:
1.After selecting a channel, press the Mode/ Power button until the small numbers next to the channel number flash on the LCD.
2.Press the Channel Up or Channel Down button to select a privacy code. You can hold the Channel Up or Channel Down button for fast advance.
3.When your desired privacy code is displayed:
a.Press the Mode/Power button to enter the new setting and proceed to other functions.
b.Press the Lock button to enter the new setting and return to Standby mode.
c.Do not press any buttons for 15 seconds to enter the new setting and return to Standby mode.
6 English
Nothing comes close to a Cobra® 7