Cobra Electronics CXT90C To install or replace batteries, Latch and sliding clip up, Belt clip

Introduction Operation Customer Assistance Warranty

Caring for YourmicroTALK® Radio

•

Your microTALK® radio will give you years of trouble-free service if cared for properly. Handle the radio gently. Keep the radio away from dust. Never put the radio in water or in a damp place. Avoid exposure to extreme temperatures.

Rechargeable Batteries and Charger

•

Remove Belt Clip	To install or replace batteries:
	1.	Remove belt clip by releasing belt clip
		latch and sliding clip up.
	2.	Pull up on the battery door latch to remove
Pull UpLock Latch		the battery compartment cover.
	3.	Insert the supplied four AAA rechargeable
		batteries or non-rechargeable alkaline
		batteries. Position batteries according to
Insert Batteries		polarity markings.
	4.	Replace battery compartment cover and
		belt clip.
Radio Charger Jack	To charge batteries in radio:
	1.	Check to see that the batteries have been
		inserted properly.

2. Insert the wall charger/adapter into the charge jack located at the top of the radio. The wall charger/adapter has two round connectors which enables you to charge either one or two radios at a time.

3.Plug the wall charger/adapter into electrical outlet.

It normally takes 15 hours to fully recharge batteries. It is not recommended to rechargebatteries more than 24 hours. Estimated operation time on a full charge is 8 hours.

Use only the supplied rechargeable batteries and wall charger/adapter for recharging your Cobra microTALK® radio.

Nothing Comes Close to a Cobra® 1