Operation
Using Your Radio
|
|
|
|
Introduction | Operation | Customer Assistance | Warranty |
Speaker/Microphone/Charge Jack
•
Speaker/Microphone/ | To attach a speaker/microphone: |
Charge Jack | 1. Open the speaker/microphone/charge |
| tab on top of your microTALK® radio. |
2. Insert the speaker/microphone accessory plug into the speaker/microphone/charge jack.
To connect a wall charger/adapter:
1.Open the speaker/microphone/charge tab on top of your microTALK® radio.
2.Insert the wall charger/adapter plug
into the speaker/microphone/charge jack.
Quick Start
1. Press and hold the Mode/Power button to turn on your radio.
2.Press the Channel Up or Channel Down button to select a channel.
Both radios must be tuned to the same channel/privacy code to communicate.
3.Press and hold the Talk button while speaking into the microphone.
4.When finished talking, release the Talk button and listen for a response.
Turning on Your microTALK® Radio
•
Press and hold the Mode/Power button until you
Battery Low
•
Battery Low | When battery power is low, the Battery Low icon |
| will blink. Your batteries should be replaced or |
| recharged, if using rechargeable batteries. |
Auto Battery Save
•
Battery Save Mode
If there are no transmissions within 10 seconds,
the radio will automatically switch to Battery
Save mode and the Power Saver icon will flash in the display. This will not affect the radio’s ability to receive incoming transmissions.
Communicating with Another Person
•
Talk Button | 1. Press and hold the Talk button. |
2. With the microphone about two inches
(5 cm) from your mouth, speak in a normal voice.
3. Release the Talk button when you are
Two Inches (5 cm) finished talking and listen for a response.
from Mouth
You cannot receive incoming calls while pressing the Talk button.
Both radios must be tuned to the same channel/privacy code to communicate.
To Select a Channel
•
Channel Button | With the radio on, select any of the |
| 22 channels by pressing the Channel Up |
| or Channel Down button. |
Mode/Power hear a series of audible tones indicating the radio
is on.
Your microTALK® radio is now in Standby mode, ready to receive transmissions. The radio is always in Standby mode except when the Talk, Call or Mode/Power buttons are pressed.
Channel Number |
Both radios must be tuned to the same channel/privacy code to communicate.
Channels 1 through 7 are shared with FRS/ GMRS. Channels 8 through 14 are FRS only. Channels 15 through 22 are GMRS only.
See page 14 for FRS/GMRS frequency allocations and compatibility charts.
|
|
|
|
|
2 English | Nothing Comes Close to a Cobra® 3 | |||