Operation | Operation |
|
|
Calling
Calling Another Party
Roger Beep Confirmation Tone
Roger Beep
Another
Party
Note
Both units must be ON and tuned to the same channel.
To alert another party that you wish to communicate:
BATT LOW | |
lock | mode |
| call |
BATT LOW
lock | mode |
call
Your listener will hear an audible tone when you release the TALK button.
This alerts the other party that you are finished talking and it’s OK for them to begin talking.
Confirmation Tone
Your incoming “Call” signal volume is dependent on the unit volume setting.
Talking To Another Party
Note
While the TALK button is depressed you cannot receive incoming calls.
1 Push and release call CALL button. The unit you are calling will hear a two second ringing tone.
Talking To Another Party
| BATT LOW |
1 Push and hold | 2 The TX/RX indicator |
TALK button. | will be displayed. |
call |
|
3 Hold mic about 2 inches | 4 Release | TALK |
from mouth. Speak in a | button and listen for | |
normal voice. | response. |
|
Listening For Another Party | Listening For | |
When finished talking: | ||
Another Party | ||
|
| Note |
1 Release TALK button to receive incoming | While the TALK button is |
depressed you cannot | |
transmissions. | receive incoming calls. |
Your microTALK® is always in listening mode when the TALK button is not pressed.
2Adjust volume by turning the On/Off Volume Switch
6
7