Cobra Electronics PR3850WX Using Your Radio, For charging microTALK radios in desktop charger

Page 4
Your microTALK® radio has a unique circuit designed to extend battery life. If there are
no transmissions for 10 seconds, the radio will automatically switch to Battery Save mode and the Power Saver icon will flash in the display.
This will not affect the radio’s ability to receive incoming transmissions.
Auto Battery Save
•
To turn on your radio:
Rotate the On/Off Volume knob clockwise to turn on your radio and adjust the volume. A series of tones will indicate the radio is on.
Your microTALK® radio is now in Standby mode, ready to receive transmissions. The radio is always in Standby mode, except when the Talk, Call or Mode/Lock buttons are pressed.
Turning on Your microTALK® Radio
•

Operation

Insert Radio(s)

Using Your Radio

For charging microTALK® radio(s) in desktop charger:

1.Insert radio(s) into desktop charger as shown.

2.Insert round connector of 120 volt adapter into jack on back of charger.

3.Plug 120 volt adapter into electrical outlet.

 

 

Operation

 

 

 

 

Introduction

Customer Assistance

Warranty

 

On/Off Power

If charging light is not on, check position of radio. Radio should be upright. The charge indicator light will stay on as long as the radio is in the charging well, even after the batteries are fully charged.

It normally takes about 15 hours to fully recharge batteries. Batteries will not be damaged if they stay in the charging well longer than that.

Each port can charge one radio. Uses 120 Volt adapter. Use only Cobra NiMH batteries, model GA-3ANH with charger model GA-CC2.

Cobra recommends your radio is turned off while being charged.

The Basics to Get You Started

Your microTALK® radio is easy to use.

To get started, simply:

1.Rotate the On/Off Volume knob to turn on your radio.

2.Press the Channel Up or Channel Down button to select a channel.

Both radios must be tuned to the same channel/privacy code to communicate.

3.Press and hold the Talk button while speaking into the microphone.

4.When finished talking, release the Talk button and listen for a response.

2English

Battery Low Battery Low

•

When battery power is low, the Battery Low icon will blink. Your batteries should be recharged or replaced if using alkaline batteries.

Battery Save Mode

Nothing Comes Close to a Cobra® 3

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Making Life Easier and Safer Product Features Channels Backlit LCD DisplayCaring for Your microTALK Radio Avoid exposure to extreme temperaturesEstimated operation time on full charge 12 hours Using Your Radio For charging microTALK radios in desktop chargerPlug 120 volt adapter into electrical outlet EnglishVolume To adjust the volume Selectable HighLow Power OutputListening for a Response When you are finished talking Call ButtonLock Feature Enter/HiLow PowerTo turn the lock feature on or off Signal Strength MeterMode Functions Mode/Lock Button To turn VOX mode on or off NOAA* All Hazards Radio ChannelsVoice Activated Transmit VOX To set VOX sensitivityMode/Lock Button To program a memory location Memory LocationsMode/Lock Button To recall a stored memory channel location Mode/Lock Button To de-program a memory location Channel ScanFlash on the display To scan channelsIf you press the Talk button while scanning, but more than Privacy Code ScanTo scan privacy codes Call Tone Settings Mode/Lock Button To change a call tone settingMemory Location Scan Mode/Lock Button To scan memory locationsKeystroke Tones General SpecificationsTo change keystroke tones FCC Licensing Product Service Questions Product Service QuestionsLimited One-Year Warranty on Radios & Charger Warranty and TrademarksTrademark Acknowledgement
Top Page Image Contents