Cobra Electronics PR 3500-2 DX VP owner manual Using Your Radio

Page 4

Using Your Radio

Operation

Introduction

 

 

 

Operation

Customer Assistance

Warranty

On/Off Power

Turning on Your microTALK® Radio

To turn on your radio:

Talk Button

Communicating with Another Person To talk to another person:

Battery Low

1.Rotate the On/Off Volume knob clockwise to turn on your radio and adjust the volume. A series of tones will indicate the radio is on.

Your microTALK® radio is now in Standby mode, ready to receive transmissions. The radio is always in Standby mode, except when the Talk, Call or Mode/Lock buttons are pressed.

Battery Low

Your microTALK® radio has a battery level meter that shows when battery power is decreasing. The greater the number of bars visible, the stronger the battery level. When the battery level is low, the last bar and “bALo” will flash

Two Inches (five cm) from Mouth

1.Press and hold the Talk button.

2.With the microphone about two inches (five cm) from your mouth, speak in a normal voice.

3.Release the Talk button when you are finished talking and listen for a response.

You cannot receive incoming calls while pressing the Talk button.

Both radios must be tuned to the same channel/privacy code to communicate.

Battery Save Mode

indicating your batteries should be replaced or, if using rechargeable batteries, recharged.

Auto Battery Save

Your microTALK® radio has a unique circuit designed to extend battery life. If there are

no transmissions for 10 seconds, the radio will automatically switch to Battery Save mode and the Power Saver icon will flash in the display.

This will not affect the radio’s ability to receive incoming transmissions.

Channel Buttons

Channel Number

Channels

To select a channel:

1.With the radio on, select any of the

22 channels by pressing the Channel Up or Channel Down button.

Both radios must be tuned to the same channel to communicate.

Channels 1 through 7 are shared by FRS and GMRS. Channels 15 through 22 are GMRS only. Channels 8 through 14 are FRS only.

See page 20 for FRS/GMRS frequency allocations and compatibility charts.

Listening

Listening for a Response

When you are finished talking:

1.Release the Talk button to receive incoming transmissions. Your microTALK® radio is always in Standby mode while the Talk or Call buttons are not pressed.

2 English

Nothing comes close to a Cobra® 3

Image 4
Contents Making Life Easier and Safer Features Product FeaturesBacklit LCD Display Batteries To install or replace batteries Avoid exposure to extreme temperaturesCaring for Your microTALK Radio Using Your Radio Volume To adjust the volume Selectable HighLow Power OutputLock Feature To turn the lock feature on or offEnter/HiLow Power Signal Strength MeterScrolling through Mode Functions Dual Function ButtonsMode Functions Mode/Lock Button To program a memory location Memory LocationsMode/Lock Button To recall a stored memory channel location Mode/Lock Button To de-program a memory location Channel ScanFlash on the display To scan channelsIf you press the Talk button while scanning, but more than Privacy Code ScanTo scan privacy codes Memory Location Scan To scan memory locationsTo change call settings Call Tone SettingsMode/Lock Button To change a call tone setting VibrAlert and Call TonesGeneral Specifications General SpecificationsSafety Information for microTALK Radios Normal PositionProduct Service Questions Warranty and Trademarks Product Service QuestionsLimited One-Year Warranty Trademark AcknowledgementEnglish