Cobra Electronics specifications How to Use Your Cobra 29 NW, Features of This Product

Page 1

Contents

How to Use Your Cobra® 29 NW

Features	1
The CB Story	A1
FCC Regulations
FCC Warnings
Included Accessories
Controls & Indicators	A2
Our Thanks to You	A3
Customer Support
Installation
Location	2
Mounting and Connection	2
Antennas
CB Antenna	6
Marine Installation	6
Ignition Noise Interference	7
Operating Your 29 NW
Turning On Your CB	8
Setting Channel Selector	9
Calibrate For SWR (Standing Wave Ratio)	10
To Receive	12
Selecting a Channel	13
S-Meter	13
NB-ANL/ANL/Off (Noise Blanker/Automatic	14
Noise Limiter Switch)
Tone Hi/Nor	15
RF Gain Control	15
Dimmer Switch	16
Setting Squelch	16
To Transmit	18
Setting Dynamike	18
Transmit	19
RF Meter	20
External Speaker	21
PA (Public Address)	22
Home And Office Set-Up	24
Temporary Mobile Set-Up	25
How Your CB Can Serve You	26
A Few Rules You Should Know	26
Channel 9 Emergency Messages	26
CB 10 Codes	28
Frequency Ranges	30
29 NW Specifications	31
Warranty Information	32
Optional Accessories	33-34
Order Form	35
If You Think You Need Service	Back Cover

Features of This Product

•40 CB Radio Channels

•Heavy-Duty Dynamic Microphone

•Full 4 Watts AM RF Power Output

•SWR Calibration Meter

•Instant Channel 19 and 9

•Front Panel 4-Pin Microphone Connector

•Antenna Warning LED

•Switchable Automatic Noise Limiter & Noise Blanker

•Adjustable Dynamike Boost

•Tactile Controls

•Illuminated Front Panel

•Dim Control

•RF Gain

•9 ft. Mic Cord

1

Image 1

Contents Features of This Product How to Use Your Cobra 29 NWLocation InstallationMounting and Connection LocationMicrophone Connector Antennas Ignition Noise Interference Marine InstallationCB Antenna CB AntennaSetting Channel Selector Setting Channel SelectorOperation Turning OnCalibrate for SWR Standing Wave Ratio Calibrate For SWR Standing Wave RatioTo Receive Selecting a ChannelMeter NB-ANL/ANL/OFF Noise Blanker/Automatic Noise Limiter Switch OFF Noise Blanker Automatic Noise Limiter SwitchTone Hi/Nor RF Gain Control Tone Hi/NorSetting Squelch Dimmer SwitchDimmer Switch Setting SquelchSetting Dynamike Setting DynamikeTransmit Select desired channelS/RF-SWR-CAL switch must be in the S/RF position Output outgoing signal while transmittingRF Meter RF MeterAdjust PA speaker volume with the Dynamike control Set CB/PA switch to PA positionPA Public Address PA Public AddressBase Station Operation From 120V AC House Current Home And Office Set-Up Temporary Mobile Set-UpTemporary Mobile Set-Up Base Station Operation From 120V AC House CurrentFew Rules You Should Know Channel Emergency Messages How Your CB Can Serve YouCB 10-Codes CB 10-CodesFrequency Ranges NW Specifications Cobra Electronics Corporation Limited Two Year Warranty Optional AccessoriesOrdering From U.S.A For Credit Card Orders Optional Accessories Accessory Order InfoMake Check or Money Order Payable To To Order OnlineCB Story If You Think You Need ServiceFCC Regulations FCC WarningsCobra Customer Service Controls and Indicators Our Thanks to YouCustomer Support Back Side