Section IV Operation (Continued)
OPERATING PROCEDURE TO RECEIVE WEATHER BAND continued
3.If threatening weather is nearby, the National Weather Service may broadcast a 10 second alert tone. This tone will be heard through the CB, even if the WX/CB Switch is in the CB mode or the unit is turned off (see NOTE below). This enables you to monitor CB frequencies and still be warned by the National Weather Service Emergency Alert. When you hear the alert, place the WX/CB Switch in the WX position. You will then be able to hear the Weather Warning Broadcast.
NOTE: If you are using the CB Mode, remember to change the WX/CB Switch from CB to WX every so often to make sure you are continually tuned to the clearest weather band channel in case an alert is broadcast.
FREQUENCY COUNTER/LCD DIGITAL CLOCK
1.Located on the right side of the LCD is the Counter/Clock Indicator.
2.For proper procedure to set your LCD Clock, there are the following features: TIME SET: 2 switches (used to set time).
COUNTER/CLOCK: 1 switch (used to select display).
TO SET TIME
1.Press FREQ. CTR./CLOCK Switch to select the clock.
2.HOUR SWITCH: Press this switch to get correct hour setting.
3.MINUTE SWITCH: Press this switch to get correct minutes setting.
NOTE: the 2010 GTL WX uses a
Display Reads
01:00
12:00
18:00
24:00
FREQ. CTR./CLOCK:
On power up, the display shows channel number and frequency being received. Pressing thr FREQ. CTR./ CLOCK button will select the Clock. Clock mode only is displayed in the WX (weather) mode. When switching out of WX mode, the display will continue to show the clock until the FREQ. CTR./CLOCK button is pressed
again.11
Time Is:
1:00 a.m.
12:00 noon
6:00 p.m.
12:00 midnight
Cobra ® | 2010 GTL WX | ||||
|
|
|
|
| H O U R |
R X | L S B | ||||
|
| : |
|
| M I N |
|
|
|
| F R E Q . C T R . | |
|
|
| |||
|
|
|
|
| C L O C K |
Display in RX mode with Clock showing.