Time Mode

10.Press the Up or Down button until +TX appears flashing; then press the Monitor (M) button to confirm the alarm transmit setting.

NOTE: This mode will only operate if the radio ID is enabled on and the unit’s temperature triggers a temperature alarm.

The Time mode provides you with a reliable clock which not only indicates the time-of-day on a 12 or 24 hour basis, but also permits an alarm set capability provided the beep tone feature is enabled. To access the time mode, proceed as follows:

1.From the GMRS TWO WAY mode (CH and CODE displayed), press the Function(F) button 5 times; TIME is momentarily displayed, followed by the indication in AM or PM.

2.To set the clock to a 12 hour display, press the right menu button once; the hours digits will flash. (To access the 24 hour display, press the Up or Down buttons until the AM/PM indication disappears from the display; then proceed with the hour/minute setting.)

3.Press the Up button or Down button; the hour indication will change between 1 and 12 accordingly. As the hour indication passes through 12 noon, the AM indication changes to PM.

4.When the hour is set, press the right menu button again; the minutes indication will flash.

5.Press the Up or Down button; the minutes indication will change between 00 and 59 accordingly.

6.Press the right menu button again; ALARM will appear with ON or OFF

flashing, together with the alarm icon ( ).

7.Press the Up or Down button to set the alarm ON or OFF as desired.

8.If ON is selected, use the right/ left and Up/Down buttons to select the desired time of alarm in the same manner as time-set in steps 2 through 5 above.

9.After all time functions have been selected and entered, press the Monitor (M) button to confirm.

When the alarm time is reached, the unit will repeat four short beeps at 5-second intervals; pressing any button during the alarm will snooze the alarm for 5 minutes. To disable the alarm, repeat the above procedure and select OFF at step 7.