Troubleshooting
Problem | Possible cause | Correction | |
No transmission | Weak batteries | Replace batteries | |
while pressing | Incorrect battery polarity | Install the batteries | |
the PTT Button |
| following the directions in | |
|
| paragraph Installing the | |
|
| Batteries. | |
Weak or no | Weak batteries | Replace batteries |
|
signal received | Channel and privacy | Adjust the transceiver’s | |
| code not set the same | settings to match those | |
| as target transceiver | settings of the target | |
|
| transceiver | |
| Volume level too low | Increase volume level | |
| PTT Button inadvertently | Release PTT Button | |
| pressed |
|
|
| Excessive radio interference | Change to a different | |
| on a particular channel | channel | |
| Obstruction of radio signal | Avoid operating in or near | |
|
| large buildings or vehicles | |
Unit beeps, but | Batteries extremely | Replace batteries | |
will not function | discharged |
|
|
when turned on |
|
|
|
Reception of | CTCSS privacy mode | Turn on the CTCSS privacy | |
unwanted signals | not on | mode and set code number to | |
|
| match the setting of the | |
|
| target transceiver. | |
| Interference from | Turn the devices off or move |
|
| electronic devices such | farther away from them. | |
|
|
|
|
| 22 |
|
|
|
|
| |
|
| 22 of 28 |