Battery Installation

Your FR548-2CH requires four AAA alkaline or four rechargeable AAA cells. Alkaline batteries will pro- vide the best performance from your transceiver. Remove the battery cover by releasing the clip latch at the top, and sliding the clip up and away from the back of the unit. Slide the battery cover downward while applying pressure at the embossed arrow. Observe the polarity symbols inside the battery tray when installing the batteries.

CLIPEMBOSSED

RELEASEARROW LATCH

BATTERY

COVER

WHEN TO USE THE CHARGING ADAPTER KIT

The Battery Charging Adapter Kit consists of an AC Wall Adapter/Charging Trans- former and a Desk-Top Charging Stand; it can be used only if the FRS radio is equipped with four rechargeable 1.2 Volt, 600mAh Audiovox Nickel Metal hydride

rechargable batteries (P/N: ABC6CF1).

Charging the FR548-2CH:

Insert the charging transformer into a household electrical outlet and connect its power jack to the PWR socket on the rear of the charging stand. Simply placing the unit into the charging stand will begin the charging process. The red LED on the front of the charging transformer serves as a charge indicator. The charging stand will charge two units simultaneously. Approximately 12-16 hours are required to fully charge the batteries. Remember to turn your FR548-2CH OFF before placing it into the charging stand.

CAUTION: The charging stand in your kit is intended for use with the supplied batteries. Do not attempt to recharge any other batteries with the charging stand.

-8-

128-6282A

8 of 16