Audiovox GMRS7015RC owner manual Battery Alert, Charging Procedure

Page 20

-If a stored memory channel is inactive for listening purposes, wait 5 seconds to see if it clears; and then proceed to the next available channel signal using the auto scan feature.

NOTE: When the Scan (S) button is pressed during auto scan or manual scan mode, the unit returns to the home channel.

Battery Alert

When the battery icon is empty ( ) and flashing on the display, recharge unit or install fresh batteries.

The battery status is displayed in the top right corner of the LCD with 1,2 or 3 bars (1 bar = low charge, 3 bars = full charge).

Battery Charge Status and Charging Instructions

Initial Charging Sequence

1.Remove batteries from plastic wrapper.

2.Insert batteries into each radio, observing polarity.

3.Place each radio in the charger base (charging LEDs should be on)

4.Charge for 6-7 hours.

Charging Procedure:

The LED on the charger base will light red as the battery level is read.

There are three battery icon bar segments indicating the battery charge level during charging:

Once the charge reaches the designated voltage, the slow-charging mode will take effect:

1.The LED on the desktop charger will be off when the slow-charging mode is in effect.

2.The battery icon on the LCD displays three bars to indicate a full charge level.

3.After 3 hours, battery charging is complete.

20

128-7961

20 of 28

Image 20
Contents Model GMRS7015RC 128-7961 Safety Information PerformanceBattery Care Battery DisposalModel GMRS7015RC FCC License Required Model GMRS7015RC Display Equipment and Accessories Supplied Powering theTransceiverInstalling the batteries Batteries128-7961 LED Flashlight Button Power On-Off/SCAN ButtonAdjusting the Volume 10 Push To Talk PTT Button Up Channel/Volume ButtonMonitor/Keylock Button Down Channel/Volume Button Gmrs OperationMode/SCANNER Button External Microphone MIC/Speaker SPK/CHG Jack VOX ButtonCtcss Mode Sub-Channel Selection Channel SelectionTransmit Power Selection Mode Dual Watch Mode VOX Sensitivity Level SelectionKey Tone Roger Beep ToneCall Ringer Selection Mode Channel Scan OperationAuto Key Lock Selection Mode VOX Enable OperationDisplay Backlight Enable Operation Scanner Operation Scanner Mode/Channel SelectionChannel Selection Scanner FunctionBattery Alert Charging Procedure128-7961 Troubleshooting Power Supply GeneralReceiver TransmitterMain Channel Frequencies Available Mode Band MHz Continuous Tone Coded Squelch System Tone Frequencies in HzFreq. Hz Scanner Frequencies Frequency RangeDAY Limited Warranty Audiovox Electronics Corp., Hauppauge, NY 128-7961