Setting Up and Using The Wireless EarAmp®
8b. In the receiver, turn the Program switch off, then on (towards the “up” arrow) and then, within ten seconds, press and hold the transmitter’s
9.When first setting up the Wireless EarAmp® system in a new environment, it’s always a good idea to do a walkaround while experimenting with different frequency settings, observing the receiver’s TX LED as you do so. If the light fails to light steadily as you move through the area that needs to be covered , the receiver may be receiving interference and the selected frequency or Group/Channel is probably unsuitable for use. Always pick the Group that has the greatest number of clear Channels and the Channel providing the strongest signal. The basic rule of thumb for successful wireless installations is to always try to minimize the distance between transmitter and receiver as much as possible (though not less than 10 feet) and also to try to maintain “line of sight” between the two (so that the person using the receiver can see the transmitter antenna). You may also be able to improve RF reception by relocating the transmitter or repositioning antennas.
10.Once you’ve settled on the radio frequency you want to use, it’s time to set the audio levels. Turn on your mixer and set the level of the signal you’re sending to the transmitter to unity gain (0 vu). Then slowly raise the transmitter’s
11.Set the receiver’s 2 CH/Stereo mode switch as desired. In Stereo mode, the two incoming signals are routed to the left and right earbuds, respectively. In 2 CH mode, the two incoming signals are inter- nally mixed to mono and both signals are routed to both earbuds. If the signal to be monitored is mono, set the 2 CH / Stereo switch to the up, “2 CH” position. See Appendix C on page 12 in this manual for more information about the use of 2 CH mode.
12.Start by setting the receiver’s Balance control (see #15 on page 7) to its center detented position. and by turning the Loudness switch (see #11 on page 7) off.
13.Connect the supplied earbuds (or
14.Finally, while playing or singing at a normal performance level, slowly turn up the receiver’s volume control until you achieve the desired level. The EarAmp® receiver should always be used at as low a volume as possible. If you hear ringing in your ears, turn down the volume control and operate it at a lower level!
15.Adjust the Balance control as needed in order to get the best blend of the incoming signals. If necessary, use the supplied screwdriver to adjust the Limiter Level, Bass and Treble trimpots (see #3, 4 and 5 on page 6) in order to optimize the sound you’re hearing. If you’re operating at low signal levels, turning the loudness control on will help improve legibility.
16.Close the battery door and clip the receiver to your belt.
If you encounter difficulty with any aspect of setting up or using your Wireless EarAmp® , you can call Samson Technical Support
9