Samson RT80 owner manual Appendix C Using 2 Ch Mode, Out

Page 14

Appendix C: Using 2 Ch Mode

The Wireless EarAmp®’ s unique dual mono “2 CH” mode makes it possible for you to have direct control over the blend of two separate signals, simply by turning the Balance knob. If you’re a vocalist, the most typical application is to route the vocal signal only to one mixer aux send and the instrument accompaniment signal to the other aux send, as shown in the illustration below. This way, by turning the Balance knob one way, you’ll hear more of your vocal and less of the instruments; by turning it the other way, you’ll hear less of your vocal and more of the instruments.

SAMSON

Aux 1

Aux 2

out

out

(vocal)

(instruments)

EarAmp®

SAMSON PHONES

POWER

RT80 UHF SYNTHESIZED

ANTENNA

PHONES LEVEL

INPUT LEVEL EarAmp®

-2 0 2

-2 0 2

 

-4

4

-4

4

-6

6

-6

6

-8

 

8

-8

8

-10

10

 

-10

10

SAMSON

UHF STEREO MONITOR AMP

Similarly, if you’re a guitarist, you can route guitar signal only to one mixer aux send and a mix of all other signals to the other mixer aux send; the Wireless EarAmp® Balance control will then give you the ability to hear as much or as little of your instrument— relative to the overall mix— as you like.

12

Image 14
Contents EarAmp Table of Contents Introduction Wireless EarAmp System Features QuickStart Guided Tour Wireless EarAmp Transmitter Front Panel 2a 2bGuided Tour Wireless EarAmp Transmitter Rear Panel Guided Tour Wireless EarAmp Receiver 13 14 Setting Up and Using The Wireless EarAmp EarAmp receiverSetting Up and Using The Wireless EarAmp Appendix a Setting the Wireless EarAmp Radio Frequency Appendix B Wireless EarAmp Channel Plan Appendix C Using 2 Ch Mode OutAppendix D Using Third-Party Earpieces Specifications System