Uniden DCT736 manual Setting up the Phonebook, Resetting Handsets, Creating Phonebook Entries

Resetting Handsets
If you want to register a handset to a different base or replace a handset with an-
other one, you must first clear the registration information from the base and the
handset.
1.	Press and hold [ ] and [#/ ] on the handset for at least 5 seconds until the
	SYSTEM RESET menu appears. Select the DEREGISTER HS submenu.
.	WHICH HANDSET? appears.		.
	Move the cursor to select the handset ID to be de-registered from the list, and then press
	DEREGISTER HS appears.
3.	The phone asks you to confirm the deregistration. Move the cursor to select YES, then press		. A
	confirmation tone sounds. The handset clears the registration information from the base and then	deletes its
	own link to the base. The handset now displays MODELS VARY! CHARGE HANDSET ON THE BASE FOR
	REGISTRATION OR REFER TO OWNER’S MANUAL. To register the handset to a base see page 21.

Setting up the Phonebook

Your phone lets you store up to 100 names and numbers in your phonebook in the handset. Your phone shares memory between your phonebook and CID en-

tries. Once you store 100 phonebook entries, CID information is not stored and only appears during a new incoming call. When phonebook and CID entries are full, a beep sounds and MEMORY FULL appears. You cannot store any additional names and numbers unless you delete some of the existing ones.

You can also use the phonebook to store a group of numbers (up to 20 digits). that you may need to enter once your call connects. This is referred to.

as chain dialing (See page 30 for instructions).

Creating Phonebook Entries

To store names and numbers in your phonebook, follow these steps:

1.When the phone is in standby mode, press [].

.To create a new phonebook entry, move the cursor to select STORE NEW.

3.Press . STORE/EDIT NAME appears.

22