Uniden DS 805 quick start Iii

Registering your phone

This additional Handset is able to be used in conjunction with models DS815, DS825, DS845 and DS875 cordless telephones.

The new handset needs to be allocated a handset number and registered to the Main

Base (DS815, DS825, DS845 & DS875). The Main Base has a telephone cord plugged into it and also has an Antenna, not to be confused with the additional charger(s).

P	P	P
DS815 Main Base	DS825 Main Base	DS845 Main Base

O

DS805 Charger

The original handset supplied with the Main Base is already registered as handset 1, this leaves handset numbers 2 - 7 available. It is very important to allocate each handset a different number to enable functions such as Call Transfer.

Registration Process

Follow this process for each DS805 additional handset that needs to be registered to the Main Base.

1.Remove the handset from its charger

2.Press flash/reg on the handset (Fig 1).

3Press the number 2 (Fig 2) for handset 2.

If you have additional handsets, repeat the same process, but at Step 2 select a number from 3 - 7 to register the next handset as (fig 3)

	REGISTER AS	REGISTER AS
		HAND # (3 - 7)
	HAND #2
Fig 1.	Fig 2.	Fig 3.

4. Place the handset in the Main Base Unit (Fig 4).

5. Press and hold the Registration button located on the back of the Main Base unit near the DC power jack (Fig 4). Hold the Registration button in until a long beep confirms the handset has been registered.

The Registration process needs to be completed within 15 seconds, 3 beep tones will indicate that the time has been exceeded. Please start the process again.

	HANDSET:	1	TALK HIGH 1		Handset
	NEW:	1			Registration
					number
	TOTAL:	1
					displayed
	Charging			On a Call
Fig 4.			Fig 5.

After Registration the handset number is shown on the Display screen either during a call or while the handset is charging (Fig 5).

If a handset is registered at any time as handset 1, all other handsets will need to be registered again from Step 1.

(iii)