Uniden XS210 manual Chain Dialing, Remove the handset from the base unit Press twice

Page 9

XS210.Qx 10/6/03 5:27 PM Page 9

If you press and a phone number is not stored in the one-touch Rocket Dial location, the phone will beep rapidly and will not dial.

If the handset battery pack is completely discharged or the battery pack is removed, the digital security code will be lost. If this happens, a new security code is set automatically next time the battery pack is charged.

One-touch Rocket Dial

Your phone is equipped with “One-touch Rocket Dial” for instant dialing. It is used to dial the phone number stored in the one-touch Rocket Dial location (See “Storing a Phone Number in Memory” on page 7).

To instantly dial the phone number stored in the one-touch Rocket Dial

location, simply press

 

. (There is no need to press

 

. The

 

 

phone will automatically dial).

 

 

 

 

CHAIN DIALING

The memory locations on the handset are not limited to phone numbers. You can also store a group of numbers (up to 20 digits) that you need to enter once your call connects. This is referred to as Chain Dialing.

An example of this is a bank account number. Once you have called your bank,

and are prompted to enter the account number, simply press and the

location number ( ) where the special number has been stored.

Store your special number in memory as you would store a phone number (Refer to “Storing a Phone Number in Memory” on page 7).

ERASING A STORED NUMBER FROM MEMORY

1)Remove the handset from the base unit.

2)Press twice.

3)Press or the memory location ( ). A tone indicates that the stored number is erased from memory.

CHANGING THE DIGITAL SECURITY CODE

The digital security code is an identification code used to connect the handset and the base unit. Normally, setting the code is not necessary.

The first time you charge your handset, the security code is automatically set. In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code.

1)Remove the handset from the base unit. Press and hold on the base.

2)The handset begins emitting a paging sound. While holding

, place the handset in the base unit. The paging sound stops. Leave the handset in the base for more than 3 seconds. A new random security code is set.

8

Image 9
Contents XS210 Choosing the best location for your XS210 Installation & SafetyInstalling Base Unit Make sure the plug is the right way round Company PhilosophyTo hang up press Handset on Base UnitBase Handset AC Adapter Telephone Cord Rechargeable Battery Controls and FunctionsIncluded with Your Phone Using Your Phone Battery MaintenanceBattery use time per charge Low Battery AlertTraveling OUT-OF-RANGE Earpiece volumeRinger tone Ringer muteFlash and Call Waiting NEW Zealand Press to switch between callersPause Dialing a Stored NumberRemove the handset from the base unit Press twice Chain DialingStatus TroubleshootingWarranty WarrantyThank YOU for Purchasing a Uniden Phone