Uniden EXI2960, EXI2965 manual E T T I N G S Ta R T E D

Page 10

•The handset can be placed up or face down in the base for charging.

•You have to remove the beltclip, if attached for face up charging.

Place the power cord so that it does not create a trip hazard or where it could become chafed and create a fire or electrical hazard.

2)Set the base on a desk or tabletop, and place the handset on the base unit as shown. Remove the beltclip, if attached, for face up charging. (See "Mounting the Base Unit on a Wall", on page 11.)

3)Then raise the antenna to a vertical position.

4)Make sure that the status LED lights. If the LED does not light, check to see that the AC adapter is plugged in and that the handset makes good contact with the base charging contacts.

•Use only the supplied AD-310 AC adapter. Do not use any other AC adapter.

•Connect the AC adapter to a continuous power supply.

•Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.

•After installing the battery pack in the handset, charge your handset at least 15-20 hours before plugging into the phone line. Once the handset battery pack is fully charged, connect the telephone line cord to the base and telephone wall outlet.

5)Connect the telephone line cord to the TEL LINE jack and to a telephone outlet once the handset is fully charged.

If your telephone outlet isn't modular, contact your telephone company for assistance.

Modular

[ 8 ] G E T T I N G S TA R T E D

Image 10

Contents Page Welcome Features Contents Controls and Functions 6 to Read this First12 to Checking the Package Contents Choose the best location Setting up the PhoneDo the following steps Battery use time per charge Connect the base unit Low Battery AlertCleaning the Battery Charging Contacts ContactsE T T I N G S TA R T E D Choose the dialing mode Mounting the Base Unit on a Wall Setting the handset retainer clip for wall mountingStandard wall plate mounting Direct wall mounting Setting Caller ID Options Entering Your Area Code Terminology Making and Receiving CallsHandset On Base Ringer tone and volume Adjusting the Handset Ringer and Earpiece VolumeTone Dialing Switch-over Earpiece volumeSelecting a Different Channel Traveling Out-of-RangeFlash and Call Waiting Storing Phone Numbers and Names You haveEntering a name Steps for Entering Names and Special CharactersIf you make a mistake while Number of times key is pressedMaking Calls with Memory Dialing Memory dialing from Standby ModeMemory dialing from Talk Mode Display a Programmed NumberChain Dialing Editing a Stored Name and/or Phone NumberErasing a Stored Name and Phone Number 7Press select or deleteYou must subscribe to Caller ID service to use this feature When the Telephone RingsCaller ID Deleting Information from the Caller ID List When the pointer is at ¨ Yes¨ When the pointer is at ¨ No¨Viewing the Caller ID Message List Deleting a Caller ID messageWhen the pointer is at ¨No¨ When the pointer is at ¨Yes¨Deleting all Caller ID names/numbers Calling a party from the Caller ID list Using the Caller ID ListLong Distance calls and Area Code Setting/Cancellation Dial editStoring Caller ID messages in Memory dialing Changing the Digital Security Code Information AdditionalTo a t t a c h t h e b e l t c l i p Installing the BeltclipHeadset Installation To re m ove t h e b e l t c l i pWhen slightly dirty MaintenanceBattery replacement and handling When very dirtyTroubleshooting Symptom SuggestionGeneral Information Battery InformationAC Adapter Information At Uniden, we´ll take care of you Please do not Return this Product to the Place of PurchaseIndex K, L