Uniden EXP2800 manual Using Your Phone, Choose the dialing mode, Making and Receiving Calls

After installing the battery pack in the handset, charge your handset at least 15-20 hours before plugging into the phone line. Once the handset battery pack is fully charged, connect the telephone line cord to the base and telephone wall outlet.

5) Connect the telephone line cord to the TEL LINE jack and a telephone outlet once the handset is fully charged.

TIP: If your telephone outlet isn’t modular, contact your telephone company for assistance.

Modular

D. Choose the dialing mode

Most phone systems use tone dialing which sends DTMF tones through the phone lines. However some phone systems still use pulse dialing such as in rural areas. The default setting is tone dialing. Depending on your dialing system, set the mode as follows:

1)Press and hold flash until you hear a confirmation tone.

2)To set the dial mode for pulse dialing, press #. Or to set the dial mode for tone dialing, press */tone. A confirmation tone sounds to indicate the setting is complete.

•if you are not sure of your dialing system, set for tone dialing. Make a trial call. If the call connects, leave the setting as is, otherwise set for pulse dialing.

•If your phone dialing system requires pulse dialing and you need to send DTMF tones for certain situations during a call, you may “switch-over” to tone dialing. (Refer to “Tone Dialing Switch-over”).

NOTE: Make sure your battery pack is fully charged before choosing the dial mode.

Using Your Phone

Making and Receiving Calls

		Handset On Base		Handset Off Base
Answer call	When the phone rings, remove the handset		Press any key.
	from the base. (AutoTalk)
	1)	Remove the handset from the base and press talk.	1)	Pick up the handset and press talk.
Make call	2) The talk/batt LED flashes.		2)	The talk/batt LED flashes.
	3)	Listen for the dial tone.	3)	Listen for the dial tone.
	4)	Dial the number.	4)	Dial the number.
Hang up	Return handset to the base. (AutoStandby)		Press talk.
	1)	Remove the handset from the base and press talk.	1)	Pick up the handset and press talk.
Redial	2) Listen for the dial tone.		2)	Listen for the dial tone.
	3)	Press redial to dial the last dialed number.	3)	Press redial to dial the last dialed number.

NOTES: • The redial key redials the last number dialed.

• The redialed number can be up to 32 digits long.

4