Page
To locate the handset (while it’s off the base), press page/find on the base. The handset beeps for 60 seconds.
Paging is canceled when pressing any key, page/find on the base or return the handset to the base.
Flash and Call Waiting
If you have “call waiting” service and a call waiting tone sounds while you are on a call, press flash to accept the waiting call. There is a short pause, then you will hear the new caller. To return to the original caller, press flash again.
NOTE: You must subscribe through your local telephone company to receive
Call Waiting Service.
Storing a Phone Number in Memory
Your EXP2800 phone has 10 memory locations for storing important telephone numbers.
1) Remove the handset from the base.
2) Press m. The talk/batt LED flashes.
3) Enter the phone number, up to 16 digits. If a pause is needed during the dialing sequence, press pause to insert a pause. Each pause counts as a digit and represents a two second delay in time between digits as they are sent.
4) Press m again.
5) Enter the memory location
NOTES: • The pause button counts as one digit. Pressing pause more than once increases the length of pause between numbers.
•You have 20 seconds after pressing m to enter the number you wish to store. Otherwise, an error tone will sound.
•You cannot store numbers in m1, m2, or m3.
Dialing a Stored Number
Using the memory location features
1)Press talk, then press m.
2)Enter the memory location
NOTE: If you select a memory location that does not have a stored number, the handset will beep rapidly and the phone will not dial.
6