•When the memory is full, you will hear a beep and “Memory Full” appears. You cannot store names and numbers.
•The pause key counts as one digit. Pressing redial/p more than once increases the length of pause between numbers.
•If you select a Speed dial location where a number is already stored, the new number will replace the old number, and the old number will be stored as a phonebook location.
2) Press select/ch, “Store/Edit Name” appears.
3) Store the name (up to 16 characters) by using the number keypad.
•See the “Steps for entering names and special characters” (see page 27).
• Use call id/ and | /RocketDial/ to move the cursor to the desired location. |
•Use xfer/del to delete characters as needed.
•Press and hold xfer/del to delete all the characters.
If a name is not required, go to step 4.
4) Press select/ch to store the name, “Store/Edit No.” appears.
5)Press the number keypad to enter the phone number (up to 20 digits), press select/ch to store the number.
6) “Distinctive Ring” appears. Press + or - to move the pointer to one of the Distinctive Ring options, then press select/ch.
If you choose not to store a “Distinctive Ring”, simply select the “No Selectn” option.
7) “Speed Dial” appears. Press + or - to move the pointer to select the Speed dial location (10 locations:
If you choose not to store the name/number as a Speed Dial, simply select the “No Selectn” option.
8)Press select/ch. You will hear a confirmation tone and “Done!” appears on the display.