Uniden EXP90 manual Mounting Directly on a Wall

Page 6

5. Raise the antenna on the base.

6.Plug the AC Adapter into a standard 120V AC wall outlet that is not controlled by a wall switch.

Mounting Directly on a Wall

If you do not have a standard wall plate, you can mount the phone directly on a wall. Before mounting your cordless telephone, consider the following:

Select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall.

Make sure the wall material is capable of supporting the weight of the base and handset; otherwise, damage to the unit could result.

Use #10 screws with anchoring devices suitable for the wall material where the base will be placed.

1. Insert the screws, with their appropriate anchor device, 3 5/16 inches apart. Allow 3/16 of an inch between the wall and screw heads for mounting the phone.

2. Plug the AC Adapter into the base.

3. Place the AC Adapter cord inside the left channel cord holder.

4. Plug one end of the long telephone cord into the TEL LINE jack on the base.

5. Place the telephone cord into the right channel cord holder.

6. Place the base on the screws and push down until it’s firmly seated.

After the unit is mounted, raise the antenna.

7.Plug the other end of the telephone line into the telephone wall jack.

8.Plug the AC Adapter into a standard 120V AC wall outlet that is not controlled by a wall switch.

Use only the AC adapter that came with the phone.

6

Image 6
Contents Page Contents IntroductionIncluded with Your EXP90 Series Phone AC AdapterControls and Functions Talk used to answer calls Keypad touchpad keysDesk or Tabletop Installation InstallationSetting the Dial Mode Switch Wall InstallationMounting Directly on a Wall Adjusting Ringer/Volume Controls Setting Up Your PhoneInstalling the Battery Pack Extending the AntennaEXP93 Charging Cradle Back of the HandsetUsing Your Phone Erasing a Stored Number Using the Flash ButtonUsing the Page/Find Feature Selecting a Different ChannelTroubleshooting Specifications