Register the Handset
You need to register the TXC400 before use.
To register the additional handset, do the following steps in compliance with your original unit.
For TRU446/TRU4465/TRU448/TRU4485 unit
Place the TXC400 handset on the original unit’s base until you hear a confirmation tone. If the original base is mounted, you will need to hold the handset to the base until the status LED on the unit’s base is illuminated.
•If the original base is a TRU448, to register the TXC400, place the TXC400 on the TRU448 base with the keypad facing down.
• If you did not hear the confirmation tone, register the TXC400 again.
•In some cases you may need to attempt registration a few times.
For TRUC46 (Card Phone) unit
1
2 Press and hold PAGE on the TRUC46 base, while you plug in the AC Adapter, until the status LED on the base flashes.
3 Press talk/flash on the TXC400’s handset.
“Handset Registering” appears. When the operation is finished, you will hear a confirmation tone and “Registration Complete” will appear. The status LED is no longer illuminated.
•If the registration fails, “Registration Failed” appears. Register the TXC400 again.
• You must complete the registration operation within 30 seconds, or the phone returns to the standby mode.
If you changed the digital security code of the original unit:
You need to perform the following steps:
1
2 Register the TXC400 to the original base by following the steps above.
– 5 –